What if we want to install components on a single column C hydraulic press? Let's talk about the components mounted on a single column C hydraulic press.
Resonance between components mounted on a single column hydraulic press. The springs of two or more valves resonate. Resonance of valve springs and piping, such as the relief valve spring and pilot remote tube, the bourdon tube in the pressure gauge and the remaining tubing.
Valve springs and air resonance: such as horizontal frame hydraulic valve spring and remote control port valve regenerative air, check valve and valve resonance. Single column horizontal hydraulic cylinder of the four column hydraulic press manual tools selection of air combustion life plug vibration. Oil movement noise and return pipe vibration. Fuel tank consensus.
Guide hydraulic press double pump oil supply circuit, two pump outlet convergence zone vibration and noise. Valve reversals cause shock noise and vibration in the pipeline due to sudden changes in pressure and hydraulic shock. Pressure relays, safety valves, check valves, etc. in the system may vibrate and make noise due to frequent pressure changes in the unloading circuit that USES the accumulator pressure to keep the pressure relay transmitting signals.
Hammering often occurs when there is back pressure at the outlet of the hydraulic control check valve. From other causes of hydraulic guide machine vibration and noise motor vibration, bearing wear caused vibration. The motor coupling of pump and guide rail hydraulic press is installed in different ways (when rigid connection is required, coaxiality ≤0.05mm, and when flexible connection ≤0.15mni).
Influence of external vibration source of single column guide hydraulic press, including vibration of load. The tank is not strong enough. For example, the top of a fuel tank is usually mounted on the bottom plate of an "electric hydraulic pump." Thickness is too thin, rigidity is not good, vibration occurs during operation.
WeChat QR code
Tiktok QR code